Creating Stripe Integration Credentials

This topic explains how to create Integration Credentials which you can use to connect your native Stripe Integration Configurations in m3ter with your Stripe system. See Configuring Stripe Integrations.

Tip: Stripe or Stripe (Test Mode)? The steps to create a Credential for authenticating an integration with your Stripe test environment are the same, except you'll need to select Stripe (Test Mode) as the destination.

To create Stripe integration Credentials:

1. Select Integrations:

2. In the Integrations section, select Credentials:

The Credentials page opens in Grid view and any existing Credentials are listed.

Tip: Credentials List View? Alternatively, you can switch to List view and start your create workflow from there.

3. Select Configure new credentials. The Create page opens at Stage 1: Select a destination and a name.

4. Enter Credential details:

Destination. Use the drop-down list to select Stripe.
Name. Descriptive name for the Credential.

Tip: Stripe Test Environment? Alternatively, select Stripe (Test Mode) for Destination if you want to use the Credential to authenticate with your Stripe test environment.

5. Select Next. The page adjusts to show Stage 1 as checked-off and completed and shifts focus to Stage 2: Configure and create:

Under Stripe Connection, an information panel shows advising that you'll need to provide authentication details on the Stripe website.

6. Select Go to Stripe. Under Get started with Stripe, log into your Stripe account and approve access for m3ter.

7. Select the Return to m3ter link at the left-hand side to be taken back to Create page.

8. Select Create credential. You are returned to the Credentials page Grid view where the Credential is listed on the Stripe card:

The Credential is now available for connecting your Stripe Integration Configuration with Stripe. See Configuring Stripe Integrations>Setting Up Authentication for the Integration.

Warning: Authentication with Stripe not completed! If you fail to complete authentication with your Stripe instance promptly, a time-to-live (TTL) of ten minutes is imposed after which the Credential is removed and you'll have to start again. If you return to the Credentials page within that TTL, any Credentials waiting for authentication completion will have a suffix of "Incomplete" attached, such as: Stripe Credential 1 (Incomplete).

Creating Stripe Integration Credentials

Additional Support